The talented Mr. Stellarpower from Scotland was close to be successful in repairing “OpenBCI made in China” in the www.openbci.com forum

Last Updated on June 7, 2024 by pg@petergamma.org

Stellarpower

https://github.com/stellarpower

managed to get a 16 channel OpenBCI made in China with WIFI to work according the following instruction:

«

  • FYI, to connect to the wireless, you need to remove the layer below.
  • Just going from memory, but if yours has those three layers like this.
  • I needed to unscrew the standoffs, remove the top layer, remove the middle layer, then re-connect the top layer
  • so in essence, you’re just powering the wifi shield.
  • Then you need to connect it to the wireless through a web browser.
  • Once complete, you can power it off again, and reconnect the middle layer back to normal.
  • Then that should allow it to send data.

«

https://openbci.com/forum/index.php?p=/discussion/comment/19681#Comment_19681

  • Stellarpower only had issues with the WIFI shield.
  • But the issues with the WIFI shield are known since a long time.
  • There are instruction available how to resolve those.

https://openbci.com/forum/index.php?p=/discussion/3502/cyton-wifi-packet-loss-noise-issues/p1

  • Unfortunately Stellarpower received little or no support in the www.openbci.forum. or only negative reactions.
  • www.openbci.com seems not to support “OpenBCI made in China”.
  • But Peter Gamma from www.petergamma.org gives 4 out of 5 stars to for the talented Mr. Stellarpower from Scotland
  • He was close to be successful in repairing “OpenBCI made in China” in the www.openbci.com forum.
  • The only issue which remains to be resolved is to repair the WIFI shield
  • But how to do this has been described by others previously.
  • Unfortunately, the supporters in the www.openbci.com forum did not inform him about this.
  • Maybe it is better to find a community for “OpenBCI made in China” somewhere than in the www.openbci.com forum.

Information for product sellers

******************************************************************

Information for product sellers who do stock market speculation and scalping with products mentioned by Peter Gamma on www.petergamma.org.

According to the little experience of Peter Gamma from www.petergamma.org, many of the products listed here are still full of issues which need to be resolved. If you do stock market speculation and sculping with those, you will loose Peter Gamma from www.petergamma.org as a buyer of these products and as a reviewer. Is this not risky? Will you not loose a majority of your costumers as well?

And is it not so, that society in general does not accept stock market speculation and scalping with products as those which are listed here? And will you not be politically incapable of finding a majority of the voters if you do stock market speculation and sculping with these products?

And as a consequence will you not be condemned and punished by a political referendum soon? Especially if you do this to a Swiss, since are not majority of Swiss against stock market speculations and sculping with people on a budget? And people in Switzerland are known for a lot of political referendums, since we have direct democracy in this country.

And Peter Gamma from www.petergamma.org will fight up to the European Court of Human Rights against people who do stock market speculation and sculping with the products which are mentioned on www.petergamma.org. And if they do not have yet the legal basis there to do so, he will fight for it.